12K Scissor
Alignment Lift
Model: 4812205AF
The 12,000 lb. capacity scissor alignment lifts are the juniors to the heavier duty big brother 14,000 lb. capacity scissor alignment lifts. Start lower, rise higher and take up less bay space. Five scissor lifts can fit in the same operating space as four 4-post lifts.
→ Key Benefits
→ Specifications
Five Scissor Lifts Fit in the Same Space as Four 4-Post Lifts!
- Starts Lower - 8 3/4" drive-on height for low profile vehicles
- Lifts Higher - 72" raised height for comfortable stand-up working condition
- Uses Less Space - 5 Baysavers side-by-side fit in the same space as four 4-post lifts
- Lifts Straight Up - No fore or aft movement
- Open Center Front and Rear (No Tie Bars) for optimum accessibility
- Hydraulic synchronization provides low maintenance - no chains or cables to wear out
- 172" alignment wheelbase
- Wide 28" runways and long 65" rear slip plates for maximum alignment capability on dual wheel vehicles
- Driver side free standing console with push button controls for maximum convenience
- Two different safety mechanisms for operator protection:
- Hydraulic velocity fuses located on both cylinders activate if lines or fittings are damaged
- Visual / audible mechanical safety locks engage automatically when lift is raised
- 52" approach ramps have gentler drive-on angle for low profile vehicles
- Built-in air kit for rugged optional rolling jacks expands service versatility
- Extra Long Approach Ramp for Gentle Drive-on Approach with Lower Profile Vehicles
- Highly Chemical Resistant Polyester Acrylic Epoxy Paint for Longer Lasting Durability
- ALI / ETL / CSA certified
| Maximum Capacity: | 12,000 lbs. |
| Overall Width: | 92" |
| Width Between Runways: | 36" |
| Overall Length: (Deck surface - 198" from front wheel stop to rear ramp) |
264" |
| Maximum Raised Height: | 72" |
| Minimum Lowered Height: | 8 3/4" |
| Operator Console Dimensions (width x height): | 19" x 42" |
| Lift Time: | 60 sec. |
| Standard Power Requirements: | 230 V/1 Ph, 60 Hz |
| Shipping Weight: | 6,470 lbs. |
Line Diagram (click image to enlarge)
This diagram is for promotion illustration purposes only, and should not be used as installation instructions. Contact your local Equipment Sales Specialist if further information is needed. Layout subject to change without notice, request detailed layout drawing for pit construction.
Snap-on is a trademark, registered in the United States and other countries, of Snap-on Incorporated. Other marks are marks of their respective holders. ©2008 Snap-on Incorporated. All rights reserved. By accessing and using this website, you agree that you have read and are bound by the terms and conditions set forth in the Terms & Conditions of Use, including the arbitration provisions.
