15K 2-Post
Automotive Lift
Model: 4215000S16 (symmetric)
The model 4215000S16 is a TRUCK LIFT. The heavy constructed lift columns tower the overhead to 193" above the floor level. This allows tall trucks to be raised to the max without interference. If this is too tall for your location the standard lift can be adjusted down during installation to 173". Standard low profile telescoping arms with 3 sets of screw in spindles with pads allow for level lifting of large vehicles.
Third party tested, ANSI ALCTV-2006 standard, ALI certified by ETL.
12K 2-Post
Automotive Lift
Model: 422012SS (12 ft. symmetric)
Model: 422012SS14 (14 ft. symmetric)
The 422012SS and 422012SS14 models are versatile 2-post car / truck lift.
Multi-stack pad adapters are standard, making it easy to reach the vehicle manufactures pick up points on either cars or trucks. An optional tower extension kit (JBC080) may be added. The kit comes standard to raise the lift by 12" or 24", giving a large selection, 12’ / 13’ / 14’ or 14’ / 15’ / 16’. Two hand-down operation controls ensure the operator is positioned for full viewing of the vehicle and lift lowering.
Third party tested, ANSI ALCTV-2006 standard, ALI certified by ETL.
10K 2-Post "V Series"
Automotive Lift
Models: 42010VS (12ft. symmetric)
Model: 42010VA (12 ft. asymmetric)
Simply state! The models 42010VS and 42010VA give you the highest capacity twin post lift with the best quality, features and versatility at the most reasonable cost of any North American manufactured lift.
Third party tested, ANSI ALCTV-2006 standard, ALI certified by ETL.
10K 2-Post
Automotive Lift
Model: 42010CS (12 ft. symmetric)
Model: 42010CS14 (14 ft. symmetric)
Model: 42010CA (12 ft. asymmetric)
Model: 42010CA14 (14 ft. asymmetric)
It is easy to see why this is a good fit in any service repair shop. The 42010CS / CS14 and 42010CA / CA14 has premium product features, large roll formed one piece towers, low friction "dura-glide" lift carriage slides, low wear components with plated arm pins, greasable arm pin supports, steel pulleys, dual function overhead safety shut off and more...Built to last.
Third party tested, ANSI ALCTV-2006 standard, ALI certified by ETL.
Snap-on is a trademark, registered in the United States and other countries, of Snap-on Incorporated. Other marks are marks of their respective holders. ©2008 Snap-on Incorporated. All rights reserved. By accessing and using this website, you agree that you have read and are bound by the terms and conditions set forth in the Terms & Conditions of Use, including the arbitration provisions.
